高潮抽搐潮喷毛片在线播放

Hello! Welcome to Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd!

18912476492

LOCATION:Home>>news>>Industry Dynamic>>A special tool necessary for automatic die cutting machine

Contact Us

C

Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd

Tell :0510-88991997

Fax :0510-88991997

Phone:18912476492

E-mail:rtxcsales@rtxcnu.com

Url      :www.rtxcnu.com

Zip Code:214000

Address:No. 81, Jinma Road, Hongshan Street, Xinwu District, Wuxi City


Industry Dynamic
分享至:

A special tool necessary for automatic die cutting machine

DateTime:2019/12/03

  In the design project, the die blades should be divided into high and low blades.

Sometimes the blade is not too high or low or insufficient, automatic die-cutting machine master must adjust themselves.

It is not a solution to immediately scrape off the board or put it high on the wooden floor.

There is no way to manipulate the manufacturing quality, no way to adjust the mold.

The actual operation of automatic die-cutting machine staff do not have to slowly gradually to find out the need to maintain a good die-cutting force, but the actual operation of equipment staff can be close to the best working pressure to carry out the first process of die-cutting.

This significantly speeds up the adjustment of equipment during daily task removal.

The effective method is to use the tape stick knife (only laser special tool mould and other tools can be used to insert the knife), and the high and low knife will be fully automatic hole cutting machine equipment.

In the automatic die-cutting machine before the actual operation, the rapid and accurate adjustment of mechanical equipment is very critical.

Therefore, the main style is playing an important role.

How to improve the rate of equipment calibration, in the usual work, die cutting master understand the actual operation of the die cutting machine and basic adjustment.

Only by focusing on priorities and solutions can you make your work more organized and efficient.

The application of bevel executor mold vertical suitable position shareholders will die cutting machine (according to the size of the mold and raw materials, generally in the middle of the good), and pay attention to the vertical die and die cutting machine.

There are many kinds of tape, such as tape and tape.

According to the sticky part, you can put a layer or two die-cutting wood floor, bakelite, PET and other mahogany as the bottom plate.

Place the adjusting raw material on the bottom plate, and clamp the die frame of the automatic cutting machine slowly until it presses the raw material of the die


contact us

Tell :0510-88991997

Fax :0510-88991997

Phone:18912476492

Phone:18661000660

E-mail:rtxcsales@rtxcnu.com

Url      :www.rtxcnu.com

Zip Code:214000

Address:No. 81, Jinma Road, Hongshan Street, Xinwu District, Wuxi City

Copyright (c) Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd All rights reserved 蘇ICP備2020051884號-2
网站地图